Walkthrough Before We Start
A week ahead, our lead brings a moisture meter, since cellars by the Nashua often hold dampness into June, and he checks the joists and how level each room sits.
A week ahead, our lead brings a moisture meter, since cellars by the Nashua often hold dampness into June, and he checks the joists and how level each room sits.
Every installer we send down Route 110 is NWFA certified and licensed by the Commonwealth, and the Brazil Floors insurance policy protects your house plus our crew.
When install day comes we measure every room again. Oak cartons, thresholds and trim get unpacked in your driveway first, so nothing comes up short with half a wall to go.
Twelve months of workmanship coverage start once that final row is fastened, with a mill warranty on the planks too.

Parallel rows follow the longest wall, a timeless layout that also keeps wood waste low.

Short pieces butt together at right angles, zigzagging across a den with plenty of energy.

Angled ends form crisp points that draw the eye toward a window facing the reservoir.

Running rows at forty five degrees widens a narrow bedroom visually, and older plaster walls that lean a bit become hard to notice.

Small oak squares, each rotated against the one beside it, frame a dining table handsomely.

Pairs of slats alternate direction from square to square, a traditional choice for a quiet reading room upstairs.



In Clinton, our nailed oak labor rate is $2.25/Sq Ft, felt and cleats included. With wood from our Coventry warehouse, unfinished strips cost $5.50/Sq Ft installed, while prefinished planks total $6.00/Sq Ft.
Moisture from below can creep into wood, so our lead takes meter readings from the plywood and the oak itself first. If numbers come back high, we hold off or recommend engineered oak.
Solid strips should never be nailed into concrete, but engineered oak can float over a foam pad on the slab at $2.00/Sq Ft labor, with a plastic vapor sheet underneath.
Solid strips usually spend a few days indoors adjusting to your rooms. Prefinished engineered oak tends to settle faster, and we set the timing at the estimate.
Sure. Our crew rolls the carpet up, cuts out pad and pulls tack strips for about $1.00/Sq Ft, and if furniture needs shifting from room to room, we do that for a flat $250.
Labor is paid the morning installers first carry tools through your front door, and wood from us is paid when the truck unloads. Sanding jobs get billed in two equal halves, start and finish.
Most orders leave our Coventry warehouse on a truck the next day. After the planks rest in your rooms, we book installers on a date that suits you.
Yes. Every NWFA certified installer on our crew guarantees the labor for twelve months, while whoever milled your planks warrants the wood separately.