Treads, Risers and Nosing
Treads come in red oak, white oak, hickory and maple, each 1 inch thick by 11 1/2 inches deep with a nosing and a riser.
Treads come in red oak, white oak, hickory and maple, each 1 inch thick by 11 1/2 inches deep with a nosing and a riser.
Tread samples ride in our estimator's truck, so you can hold each wood beside the floor at the bottom of the stairs.
Loose steps get screwed down first. Then each new tread is fitted to the stringer, glued and fastened so nothing creaks later.
The crew is licensed, insured and NWFA certified, and labor is warranted for one year. A step that slips gets fixed by us.



A new step is $60, with tread, riser, nosing, stain and labor all included. Ten steps come to $600 before any carpet removal.
Yes, the carpet goes, along with its pad, tack strips and staples. The removal cost is shown on your free in-home estimate.
Red oak, white oak, hickory and maple are the four we install. Our estimator sets samples against your floor so you can see the match.
A typical flight is done in one to two days. Stain and finish dry time can extend that slightly.
Yes, refinishing is $50 per step if the treads are sound. Cracked or loose ones are replaced instead.
Laminate on stairs is $50 per step in labor. The nosing is cut in a matching color.
The stain is matched to your floor on site. We test it on a scrap tread first and adjust until you approve.
Labor is warranted for one year, and the wood carries the manufacturer warranty. A step that loosens or squeaks in that time gets fixed at no charge.