Treads, Risers and Nosing
Choose red oak, white oak, hickory or maple for the treads. Each is a full inch of solid wood, 11 1/2 inches nose to back, rounded in front and paired with a riser.
Choose red oak, white oak, hickory or maple for the treads. Each is a full inch of solid wood, 11 1/2 inches nose to back, rounded in front and paired with a riser.
Stained tread samples come to Ayer in the estimator's truck. Set one on the bottom step next to your floor and the match is obvious.
Shaky steps are screwed tight first. Then the installer scribes each new tread to the skirt board, glues it and fastens it down.
Licensed, insured and NWFA certified employees build every staircase, and the labor is warrantied for one year.



Sixty dollars per step, and that single figure holds the tread, the riser, the bull nose, a stain to match your floor and the installer.
Yes. Carpet and pad come off, tack strips and staples are pulled, and the removal figure is set in writing at the estimate.
Solid oak treads can be hand sanded and refinished for $50 a step. Cracked or worn through treads are replaced instead.
Yes. Oak risers in the tread stain give an all wood look, and white paint gives a crisp contrast.
Almost always. Each loose step gets screwed down to the stringers before any tread is cut, and the new treads are glued and fastened so nothing shifts.
A mitered return goes on each exposed end so the bull nose wraps around the side and the tread is finished from every angle.
With unfinished treads the crew can start the day after the estimate and finish in about two days. Prefinished treads are special ordered and take a few weeks.
Yes. Stair labor is guaranteed for one year, and the installers are Brazil Floors employees who carry a license, insurance and NWFA certification.