Treads, Risers and Nosing
Four woods are offered: red oak, white oak, hickory and maple. Treads are 1 inch thick and 11 1/2 inches deep, with a rounded nose and a riser.
Four woods are offered: red oak, white oak, hickory and maple. Treads are 1 inch thick and 11 1/2 inches deep, with a rounded nose and a riser.
Tread samples arrive in the estimator's vehicle. Hold one against the floor at the bottom step and the right wood becomes obvious.
Any loose step is screwed tight first. After that the installer scribes each tread against the wall, glues it and fastens it.
Our staircase crews are licensed, insured and NWFA certified, and we back the labor for one full year.



It is $60 per step. The tread, riser, nosing, matching stain and labor are all part of it.
Yes. Carpet, pad, tack strips and staples are pulled, and the removal price is set at the visit.
If the oak is sound, hand sanding and refinishing are $50 per step. Cracked or worn-thin treads are replaced.
Yes. Oak risers in the tread stain give an all-wood stair, while white paint gives contrast.
Mostly. We tighten the loose steps first, then glue and fasten each new tread to keep it silent.
A return end goes on each exposed side so the nosing wraps around and the tread looks complete.
Prefinished treads can take weeks to arrive, but site-finished jobs often start the next day and finish in about two.
Yes, twelve months on labor, from a crew with licenses, insurance and NWFA certification.