Walkthrough Before We Start
In Greenridge, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Inspect the edge at that door.
In Greenridge, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Inspect the edge at that door.
By Arthur Kill Road, confirm the assembly, job scope and building access requirements before the installation date. Confirm access before booking.
For homes near Richmond Avenue, measure the usable area again after the layout is drawn and allow for the cuts it requires. Include the room dimensions.
By Arthur Kill Road, read the workmanship terms for the installed wood and save your written scope.

For homes by Richmond Avenue, follow the view from the entry when choosing a straight plank direction.

Lay out the center line for herringbone before selecting how to trim the borders.

For homes by Richmond Avenue, confirm the chevron angle and point alignment at the doorway.

In Greenridge, mark where diagonal courses will end beside every fixed edge. Note which trim stays.

In Greenridge, dry-fit a checkerboard section to inspect the pattern’s scale. Note which trim stays.

For homes near Richmond Avenue, test the basket weave repeat at a wall before deciding on the border.



Draw the entry sightline and the opening to the next room. Use a short dry layout to judge where the pattern should start. Check the clearance near Richmond Avenue.
In a house with an older stair landing, compare the thickness of both assemblies at the opening, including any padding or preparation required for the new one.
Follow the product instructions and check wood, room and subfloor conditions before installation. Check the finish in a shaded room toward Brookfield Park.
In a house with an older stair landing, identify the material and thickness under the old surface. Compare that base with the fastening requirements for the selected wood.
Compare the room conditions, approved installation methods and available height for each product before choosing. Bring a photo of the door saddle at the garden entrance.
In a house with an older stair landing, allow for cuts, pattern repeat and material selection. An estimate should use your measured layout and the particular plank size.
Test the full floor buildup against the lowest clearance at the hinge and the latch side. Record the details of the edge of a replaced upper nosing.
In a house with an older stair landing, measure the carrying route, flag any tight turn and confirm any building delivery window before ordering.