Walkthrough Before We Start
Near Clove Road, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Include the room dimensions.
Near Clove Road, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Include the room dimensions.
By Grasmere station, confirm the assembly, job scope and building access requirements before the installation date. Confirm access before booking.
For homes close to Clove Road, measure the usable area again after the layout is drawn and allow for the cuts it requires. Include the space dimensions.
Close to Clove Road, read the workmanship terms for the installed wood and save your written scope.

Follow the view from the entry when choosing a straight plank direction. Include the space dimensions.

Lay out the center line for herringbone before selecting how to trim the borders.

For homes by Clove Road, confirm the chevron angle and point alignment at the door opening.

In Grasmere, mark where diagonal courses will end beside every fixed edge. Measure the threshold too.

In Grasmere, dry-fit a checkerboard section to check the pattern’s scale. Check the edge at the door.

For homes close to Clove Road, test the basket weave repeat at a wall before deciding on the border.



Draw the entry sightline and the opening to the next room. Use a short dry layout to judge where the pattern should start. Record the details of a stair nose beside original trim.
In a house with a raised entrance, compare the thickness of both assemblies at the opening, including any padding or preparation required for the new one.
Follow the product instructions and check wood, room and subfloor conditions before installation. Include the lighting in the sunny side of a room near the station.
In a house with a raised entrance, identify the material and thickness under the old surface. Compare that base with the fastening requirements for the selected wood.
Compare the room conditions, approved installation methods and available height for each product before choosing. Measure the floor by the joint at a tiled vestibule.
In a house with a raised entrance, allow for cuts, pattern repeat and material selection. An estimate should use your measured layout and the particular plank size.
Test the full floor buildup against the lowest clearance at the hinge and the latch side. Check the clearance near Clove Road.
In a house with a raised entrance, measure the carrying route, flag any tight turn and confirm any building delivery window before ordering.