Treads, Risers and Nosing
Four woods are offered, red oak, white oak, hickory and maple. Each tread is 1 inch thick and 11 1/2 inches deep with a bull nose and a riser.
Four woods are offered, red oak, white oak, hickory and maple. Each tread is 1 inch thick and 11 1/2 inches deep with a bull nose and a riser.
Our estimator carries tread samples. Lay them beside the boards at the bottom of the flight and the best choice shows itself.
Any step that shifts is screwed tight first. The installer then scribes the new tread against the wall, glues it and fastens it, so the climb is quiet.
Every flight is built by our own NWFA certified, licensed and insured installers, and we warrant the labor for one year.



It is $60 a step. That covers the hardwood tread, the riser, the bull nose, stain matched to your floor and installation.
Yes. We remove the carpet, padding, tack strips and staples, and the removal cost is agreed when we visit.
When they are solid oak, they can be hand sanded and refinished at $50 a step. Any that are cracked or thin are swapped.
Yes. Oak risers stained like the treads give an all-wood stair, and white paint gives a sharp contrast.
On most flights, yes. We fasten loose steps first, then glue and secure each new tread.
Each exposed end gets a return, so the rounded nose wraps the side and the tread looks complete.
Material ships the next day after ordering, and your estimate sets the start of the stair work.
The labor warranty lasts a year, and the people on the stairs are licensed, insured and certified by the NWFA.