Walkthrough Before We Start
The board construction determines which fitting methods are available. During the Route 23 walkthrough, place samples across the grain of the adjoining floor.
The board construction determines which fitting methods are available. During the Route 23 walkthrough, place samples across the grain of the adjoining floor.
In Pratt Rock, verify indoor conditions before bringing boards in before deciding on layout and acclimation. Wide boards and patterned layouts need different allowances.
Bring subfloor survey into the estimate for Prattsville. We can map uneven or moving sections once the rooms have been measured.
Bring up coverage when reviewing your Prattsville scope. Ask which hardwood work is covered and what maintenance the materials require.

At the Prattsville walkthrough, note the thickness and direction of existing planks. Confirm that detail with the written scope.

Look at glue-assist options in the light you usually use in Pratt Rock. Then check adhesive and fastener compatibility.

Before ordering for Schoharie Creek, confirm the product allows a floating assembly. Allow for any detail still to be measured.

For Route 23 homes, compare the finished height before choosing the trim where new work meets a surface that will stay.

Put pattern and orientation on the Prattsville estimate if it affects the transition. Measure the visible cuts at walls and turns.

For workmanship and care in Pratt Rock, keep the floor and finish specifications with the estimate and note the floor height at the opening.



Map uneven or moving sections. In Prattsville, ask which preparation, materials, and transitions are included in the written scope.
For an older home with a ground-floor room near an exterior entry near Schoharie Creek, check whether the conditions below the floor are stable. Fixed cabinets may limit where the floating floor can run. Review that detail while the existing surface is still in place.
Bring up the nail-down hardwood when we review the rooms in Prattsville. Note the thickness and direction of existing planks.
Adhesive cannot substitute for correcting movement underneath. Before the visit, check adhesive and fastener compatibility.
Review the pad and leave the required perimeter clearance. In Prattsville, confirm the product allows a floating assembly before committing to the plan.
A reducer may be needed when the two surfaces sit at different heights. For the Prattsville estimate, compare the finished height before choosing the trim.
At the Prattsville visit, view a short mock layout before approving board direction. Diagonal runs or parquet can increase cutting waste.
Review the scope and product care instructions. Follow up with the crew about how to keep the floor and finish specifications with the estimate.