Walkthrough Before We Start
In Livingston, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Inspect the edge at that door.
In Livingston, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Inspect the edge at that door.
By County Route 19, confirm the assembly, job scope and building access requirements before the installation date. Confirm when the space is free.
For homes close to Linlithgo, measure the usable area again after the layout is drawn and allow for the cuts it requires. Inspect the edge at the door.
By County Route 19, read the workmanship terms for the installed wood and save your written scope.

For homes close to Linlithgo, follow the view from the entry when choosing a straight plank direction.

Lay out the center line for herringbone before selecting how to trim the borders.

For homes close to Linlithgo, confirm the chevron angle and point alignment at the doorway.

Near Linlithgo, mark where diagonal courses will end beside every fixed edge. Note which trim stays.

Near Linlithgo, dry-fit a checkerboard section to confirm the pattern’s scale. Note which trim stays.

Test the basket weave repeat at a wall before deciding on the border. Inspect the edge at that door.



Draw the entry sightline and the opening to the next room. Use a short dry layout to judge where the pattern should start. Check the clearance near Linlithgo.
In an older family home with a rear porch, compare the thickness of both assemblies at the opening, including any padding or preparation required for the new one.
Follow the product instructions and check wood, room and subfloor conditions before installation. Check the finish in light from tall divided windows.
In an older family home with a rear porch, identify the material and thickness under the old surface. Compare that base with the fastening requirements for the selected wood.
Compare the room conditions, approved installation methods and available height for each product before choosing. Bring a photo of the doorway between the pantry and kitchen.
In an older family home with a rear porch, allow for cuts, pattern repeat and material selection. An estimate should use your measured layout and the particular plank size.
Test the full floor buildup against the lowest clearance at the hinge and the latch side. Record the details of an uneven run down to the side entry.
Hardwood installation labor runs $2.25/Sq Ft. New wood arrives the next day, acclimates for three days and goes in on day four. Take a photo of the doorway between the pantry and kitchen before the wood arrives.