Walkthrough Before We Start
In Grymes Hill, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Compare a sample at the sill.
In Grymes Hill, mark the retained trim, doors and flooring at the walkthrough so the new hardwood meets those fixed edges. Compare a sample at the sill.
Close to Howard Avenue, confirm the assembly, job scope and building access requirements before the installation date. Note the delivery entrance.
For homes close to Howard Avenue, measure the usable area again after the layout is drawn and allow for the cuts it requires. Measure the threshold too.
Near Howard Avenue, read the workmanship terms for the installed wood and save your written scope.

For homes near Howard Avenue, follow the view from the entry when choosing a straight plank direction.

Lay out the center line for herringbone before selecting how to trim the borders.

For homes near Howard Avenue, confirm the chevron angle and point alignment at the doorway.

By Howard Avenue, mark where diagonal courses will end beside each fixed edge. Note which trim stays.

In Grymes Hill, dry-fit a checkerboard section to inspect the pattern’s scale. Note which trim stays.

Test the basket weave repeat at a wall before deciding on the border. Inspect the edge at that door.



Draw the entry sightline and the opening to the next room. Use a short dry layout to judge where the pattern should start. Bring a photo of the entry transition between two elevations.
In a hillside house with two floor levels, compare the thickness of both assemblies at the opening, including any padding or preparation required for the new one.
Follow the product instructions and check wood, room and subfloor conditions before installation. Record the details of the return at a steep stair turn.
In a hillside house with two floor levels, identify the material and thickness under the old surface. Compare that base with the fastening requirements for the selected wood.
Compare the room conditions, approved installation methods and available height for each product before choosing. Include the lighting in a bright room toward Wagner College.
In a hillside house with two floor levels, allow for cuts, pattern repeat and material selection. An estimate should use your measured layout and the particular plank size.
Test the full floor buildup against the lowest clearance at the hinge and the latch side. Measure the floor by the entry transition between two elevations.
In a hillside house with two floor levels, measure the carrying route, flag any tight turn and confirm any building delivery window before ordering.