Walkthrough Before We Start
If board selection comes up at your Route 145 address, compare solid and engineered samples. Note where the old surface will stay.
If board selection comes up at your Route 145 address, compare solid and engineered samples. Note where the old surface will stay.
For layout and acclimation near Livingstonville, verify indoor conditions before bringing boards in. That detail helps the crew mark the first run and plan the last cuts.
At your Broome visit, map uneven or moving sections. A flat base matters even when the floor will be floated.
For your Broome project, read the workmanship terms alongside the hardwood scope. Ask who to contact about an issue after the crew leaves.

Put nail-down hardwood on the Broome estimate if it affects the transition. Note the thickness and direction of existing planks.

For glue-assist options in Livingstonville, compare the board instructions with the planned base and note the floor height at the opening.

If the the Catskill Creek valley rooms need floating engineered wood, confirm the product allows a floating assembly before booking a date.

At the Route 145 walkthrough, compare the finished height before choosing the trim. Confirm that detail with the written scope.

Look at pattern and orientation in the light you usually use in Broome. Then view a short mock layout before approving board direction.

Before ordering for Livingstonville, review the scope and product care instructions. Allow for any detail still to be measured.



Map uneven or moving sections. In Broome, ask which preparation, materials, and transitions are included in the written scope.
For a house with a covered porch and a wood-floored main level near the Catskill Creek valley, check the indoor floor separately from the exterior threshold. The board construction determines which fitting methods are available. Review that detail while the existing surface is still in place.
At the Broome visit, view a short mock layout before approving board direction. Diagonal runs or parquet can increase cutting waste.
Review the scope and product care instructions. Follow up with the crew about how to keep the floor and finish specifications with the estimate.
Bring up the board selection when we review the rooms in Broome. Place samples across the grain of the adjoining floor.
A flat base matters even when the floor will be floated. Before the visit, map uneven or moving sections.
Verify indoor conditions before bringing boards in. In Broome, mark the first run and plan the last cuts before committing to the plan.
Site finishing adds time to the schedule. For the Broome estimate, test color next to the trim that will stay.