Samples on Your Own Wood
For homes close to Route 990V, prepare the test on the wood that will receive stain so its grain and base color are visible. Use the room’s usual light.
For homes close to Route 990V, prepare the test on the wood that will receive stain so its grain and base color are visible. Use the room’s usual light.
For homes close to Route 990V, prepare the sample and final surface with the same sanding sequence so the trials compare fairly. Use the room’s usual light.
For homes close to Route 990V, inspect how each species takes stain and inspect the sample for dark patches after it dries. Use the room’s usual light.
For homes by Route 990V, keep the stain and finish details with the written workmanship terms for later reference. File the care guide too.



View a dry trial with the intended finish in place, using the room’s normal daylight and evening light. Note how often you use an entry with a deep storm door sill.
Near Route 990V, yes. Prepare and finish an individual test on each species, especially when the floor includes earlier repairs.
Use a prepared sample that represents the actual wood and sanding sequence planned for the job. Note the height at the opening into a later addition.
Near Route 990V, compare the darker trial in the strongest light and at the room’s shaded edge before approving it.
Yes. Check the sample with the planned protective finish so you can judge the combined color and sheen. Check whether a lower room over a crawlspace needs work.
Near Route 990V, prepare a trial on the tread wood and place it beside a sample of the retained landing under the same light.
Label the approved sample with the stain, finish and mixing details, then store it out of direct sunlight. Photograph the entry near the Schoharie Reservoir.
Near Route 990V, bring photos of the trim and a wood offcut if available. Note any sections that were patched in the past.