Samples on Your Own Wood
Andes stain sampling should include distinct board sections. Assess the dried color with existing woodwork ahead of approval.
Andes stain sampling should include distinct board sections. Assess the dried color with existing woodwork ahead of approval.
Fine-grit sanding for Andes staining should suit the timber and finish. Confirm sanding marks before testing your proposed color.
Consistent sanding and a wet edge help keep stain even. Before coating rooms that share a doorway, review the prepared areas.
Andes staining has a one-year labor warranty under its terms. Retain sample approval, product identity and floor care instructions.



At an address near the Andes Hamlet Historic District, appearance closely at delivery access from a rural driveway. Apply the intended finish over a prepared trial. View the shade beside trim and retained boards. Repeat the check in different room light.
During your site visit near Main Street, discuss floorboards beside a retained hearth and how the rooms connect. Sample both types of boards where the rooms meet. Compare the coated results under the same light. Agree whether a match or a clear boundary works better.
For your place near Tremperskill Road, show the floor over an older cellar before settling the scope. Choose a useful location near the room entrance. Include a patch if there is one in the room. Check the results with the woodwork that stays.
If the home is near the Delaware County hills, bring a photo that shows sunlight at the front of a hamlet house. Test the shade on the tread and the nearby floor. Compare their coated samples from both directions. Approve separate trials if the wood species differ.
Make a identify about old door casing next to the main room when planning the Andes visit. Prepare a sample on the patch and on retained boards. Look at them beside each other after the coating dries. Agree on a tone range before working across the room.
Review the complete system on the actual floor. Compare the shade and sheen after the trial dries. Record the sample approved for the job.
Check the usable wood and past coating history. Try a small prepared area before committing. Decide after seeing the proposed clear coat.
Keep a note of the formula and wood species. Record the protective finish and retain a sample if possible. Test new wood separately if a future repair is needed.