Boards Matched to Yours
Most homes here use red oak or builder grade strip, and we keep matching stock to hand, then tone the new boards in layers until the patch vanishes.
Most homes here use red oak or builder grade strip, and we keep matching stock to hand, then tone the new boards in layers until the patch vanishes.
Schedule a free estimate and we measure moisture, check the subfloor from below when we can, and point out which boards truly need replacing.
Gaps at the baseboards and noise in the upstairs hall appear as lumber dries and houses shift. Boards get fastened from above, and the seams are filled with a putty toned to the wood.
Every repair is warranted for a year on labor and done by licensed, insured crew trained to NWFA standards.



They begin at $150 and are quoted on site, because each floor is different. We examine the damage and give a clear figure at the visit.
Yes, the process starts with drying and moisture readings, and cupped boards that do not recover are replaced.
Not necessarily, because moisture readings decide it, and we pull only the strips that cannot lie flat again.
We carry matching stock and tone each new board in layers to blend.
We set screws through the boards into the joists and cover the heads with filler.
Yes, using a filler colored to your oak, followed by a thin recoat.
Book the estimate online for $250 off, and a visit is usually scheduled within a few days.
One year on labor from our own employees.